Area of Rescue Command Unit
Installation Guide
Model AOR-5 / Model AOR-10
Page
14
of
23
Rev. 4/13/2022
Copyright 2022 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of
Talk-A-Phone, LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate
any approval, endorsement, sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
Programming the AOR-CSE Stations
Once the Command Unit has been programmed, the AOR-CSE Stations will need to be
programmed individually.
1.
Calling into the AOR-CSE Station to enter programming mode.
1. To call from a remote phone, dial the telephone number of the analog (PSTN/POTS)
telephone line connected to the Command Unit. Go to
Step (3)
.
2. To call from a Sub-Command Unit, simply pick up the handset.
3. In either case, you will hear one (1) beep when the Command Unit is ready.
4. Enter the code to route to a specific AOR-CSE Station:
* 4 [1 through 5 or 1 through 0] *
There will be a short pause and then the AOR-CSE Station will answer with an open
channel (microphone and speaker are active).
2.
Enter the security code:
827827
(or
TAPTAP
)
3.
Program the Primary Phone Number to dial:
[0-20 digits for phone number] # 00
For
local mode
, use
any of the following numbers
as the phone number:
5
calls the Command Unit handset
6
calls Sub-Command Unit #1
7
calls Sub-Command Unit #2
8
calls the Command Unit handset and the Sub-Command Unit(s)
—rings all at the same
time, first to pick up answers the call
For
remote mode
(i.e. calling an outside phone number), use the
10-digit phone number
of
the answering point as the phone number.
Please program the phone number in the following format depending on whether a
PSTN/POTS telephone line or analog PBX extension line is connected.
For a Central Office (CO) line from the telephone company:
1 + Area Code + 7-digit Phone Number
For a PBX extension:
9 + 1 + Area Code + 7-digit Phone Number
4.
Program the Second Phone Number to dial:
[0-20 digits for phone number] # 01
Follow the same dialing rules as outlined in
Step (3)
above.
5.
Set the call length, silence time out, ring count, and dial next number on busy:
294521 # 18
See
Timing/Dialing Options for the AOR-CSE Station (p.18)
for further details or other
options.
NOTE:
After each AOR-CSE Station programming code, two (2) beeps indicate the code has been accepted.
Four (4) beeps indicate an error
—re-enter the code again.
