Installing the light plate
Step 1.
Remove 1 of the 3 screws from the
mounting ring and loosen the other 2 screws.
(Do not remove)
Step 3.
Place the key holes on the light plate
over the 2 screws previously loosened from
the mounting ring, turn light plate until it
locks in place at the narrow section of the
key holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 15)
Figure 15
Light plate
Mounting ring
Screws
Installing the Light Kit 8.
Figure 17
Bulb
Light shade
Tabs
Light plate
Screws
Glass shade
Glass plate
Figure 16
NOTE: Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box.
Turning power off using the fan switch is not
sufficient to prevent electric shock.
Changing the Light Glass
There are 2 kinds of glass (white art glass and
amber art glass) available in your box for your
choice, use the one preferably to match your
decor. Following the steps to make proper glass
installation.
1. Remove the 4 screws from the glass plate.
(Fig. 16)
2. Replace the glass plate onto another glass
shade and secure with the 4 screws provided.
Installing the Light Kit
1. Insert the light bulb (included) into the light
kit socket. Max. 100 Watt.
2. Raise the light shade up against the light
plate and secure it to the fan by twisting
glass clockwise until the tabs on the light
plate properly sits in the notches on the glass.
DO NOT OVER TIGHTEN. (Fig. 17)
3. Restore power and your light kit is ready for
operation.
NOTE:
Light bulbs have no warranty, can be
purchased at local light bulb specialty store
or from our service center.
