Hanging the Fan
REMEMBER
to turn off the power. Follow the
steps below to hang your fan properly:
Step 1.
Remove the decorative canopy bottom
cover from the canopy by turning the cover
counter clockwise.(Fig. 5)
Step 2.
Remove the hanger bracket from the
canopy by loosening the two screws on the
bottom of the hanging bracket
from
the screw head and turning the canopy counter
clockwise.(Fig, 5)
Step 3.
Pass the 120-volt supply wires through
the center hole in the ceiling hanger bracket as
shown in Fig. 6.
Step 4.
Secure the hanger bracket to the
ceiling outlet box with the screws and washers
provided with your outlet box.
Step 5
. Remove the hanger pin, lock pin and
set screws from the top of the motor assembly.
Step 6.
Route wires exiting from the top of the
fan motor through the collar cover, canopy
cover, canopy and then through the ball /
downrod. (Fig. 7)
a half turn
WARNING
FAILURE TO PROPERLY INSTALL LOCKING PIN
AS NOTED IN STEP 7 COULD RESULT IN FAN
LOOSENING AND POSSIBLY FALLING.
Step 8.
Tighten two set screws on top of the fan
motor firmly (Figure 7)
Step 9.
Place the downrod ball into the hanger
bracket socket.
CHANGING THE DOWNROD
(OPTIONAL)
NOTE:
Your fan comes with a 4" downrod
attached to the hanger ball. In addition you
have been provided with a 6" downrod to use if
desired. If you choose to use the 6" downrod,
perform the following steps:
1. Remove the hanger ball from the 4"
downrod by loosening the set screw at the
top of the downrod which holds the hanger
ball to the downrod.
2. Slide the hanger ball down the downrod and
remove the support pin.
Step 7.
Align the holes at the bottom of the
downrod with the holes in the collar on top of
the motor housing (Fig.7). Carefully insert the
hanger pin through the holes in the collar and
downrod. Be careful not to jam the pin against
the wiring inside the downrod. Insert the
locking pin through the hole near the end of
the hanger pin until it snaps into its locked
position, as noted in the circle inset of Fig. 7.
Figure 5
Hanger
bracket
Ceiling
canopy
Canopy
cover
Mounting
screws
(supplied with
electrical box)
Hook
Ceiling
mounting
plate
UL Listed
electrical
box
Figure 6
120V Wires
Washers
3. Insert the support pin in the holes at the
top of the 6" downrod and slide the
hanger ball up the 6" downrod. Make
sure the support pin is properly seated in
the grooves in the top of the hanger ball.
4. Tighten the set screw firmly.
4.
CAUTION
Remove the 5 screws from the motor support plate,
discard the 5 screws and motor support plate.
