6.
Figure 11
Outlet box
Hanger
bracket
Canopy
Canopy
cover
Screws
SUPPLY CIRCUIT
Ground
Conductor
Outlet Box
Green
Ground
Lead
Ground to
Downrod
B
L
A
C
K
W
H
IT
E
WHITE
W
H
IT
E
WHITE
BLACK
B
L
A
C
K
BLACK
BLUE
B
L
U
E
G
R
E
E
N
Figure 10
WHITE
WHITE
BLUE
BLACK
ON
ON
Attaching the Fan
Blades
Step 1
Attach
blades to the blade arms
using three screws and rubber washers as
shown in Figure 12. Start a screw into the
arm, do not tighten. Repeat for the 2
remaining screws and washers.
Step 2
Tighten each screw securely
starting with the center screw. Make sure
the blade is straight.
the
Step 3
Fasten the blade arms to the motor
by inserting the tab from the blade arms to
the slot in the bottom motor housing, then
tighten the two screws and washers already
installed in the blade arms (Figure 13).
Step 4
Install an optional light kit if you
wish. Follow the instructions included
with the kit.
Finishing the Installation
Step 1.
Tuck connections neatly into ceiling
outlet box.
Step 2.
Slide the canopy up to ceiling and over
the 2 screws on the hanger bracket. Rotate canopy
clockwise. Next, while holding the canopy with
one hand, slide the canopy cover over the screws
and rotate clockwise until tight.
Note:
adjust the
canopy screws as necessary until the canopy and
canopy cover are snug. (Fig. 11)
WARNING
Make sure the notch on the hanging bracket
properly sits in the groove in the hanger ball
before attaching the canopy to the bracket by
turning the housing until it drops into place.
'
