Assemble the legs
The leg top has 2 sets of 2
holes for the two stand heights.
One hole is the stop and
the other is the catch. Bronze
bolt leg stops are pre-installed
for the 7 1/2 height.
Slip the leg bottom into
the leg top being careful with the
Mylar tape inside the leg top. The
leg will come to the stop about 6
inches up. Twist the leg bottom
till the holes line up.
Insert a bronze bolt into
this catch all the way (the end
almost sticks out) and fasten
with one of the bronze nuts.
Tighten both sets of bolts
with the provided allen wrench
and your pliers.
>>NOTE<<
Use the allen wrench on the bolt
side and your pliers with the nut.
Assemble the other three legs.
SET-UP INSTRUCTIONS
To floor, black urethane feet
Leg Bottom
Stop bolt
hole
Catch
bolt hole
Mylar
tape
Stop Bolt
Catch
bolt hole
These
holes
are for
the
6
1/2
Foot
height
7
1/2
f
oot
height
holes
Catch
bolt
hole
7
