TAKE-A-LABEL TAL-3000R, Руководство по эксплуатации

Страница: 19 / 41

Page 2.14
P
P
r
r
o
o
d
d
u
u
c
c
t
t
D
D
r
r
i
i
v
v
e
e
H
H
e
e
a
a
d
d
T
T
h
h
r
r
u
u
s
s
t
t
B
B
e
e
a
a
r
r
i
i
n
n
g
g
A
A
d
d
j
j
u
u
s
s
t
t
m
m
e
e
n
n
t
t
Thrust Bearings
Pivot Spacer
Thrust Bearing Nut
Checking Bearings And Lubing:
1.
Turn power off; unplug the labeler.
2. Locate the screws around the product drive motor housing and remove.
3. Note; the motor leads, unplug the motor leads and set the housing down.
4. Remove the thrust-bearing nut. Note; the thrust bearings under the
washer, remove the thrust-bearing make sure not to get dirt in the
bearing.
5. Using care, slide the product drive head, note the pivot shaft spacer.
6. Also be careful the set of thrust bearings on the inside (note: Washer,
Bearing, and Washer per set).
7. Clean, inspect and / or replace all the bearings and washers.
8. Do Not replace only part of the set.
9. Grease the bearings and pivot shaft (using a good grade of regular
grease), reassemble.