-7-
→
Templete
8.5 mm
50mm
or more deep
Floor
2
〜
5mm
CAUTION
Base Plate
Hammer
Flat Washer
Nut
Center pin
If the anchor bolt is tapped with its and contacting the bottom
of the hole, the strength will be lowered. Proper clearance
must exist between the end of the anchor bolt and the bottom
of the hole.
Do not make scratch or damage the
floor
while moving the
unit. Please use the carriage jig to move it.
4. Fix the main unit with the four screws.
Plywood Floor : Hex head tapping screw M8 x 65
Concrete Floor : Anchor bolts M8 x 70
5. When the moistureproof packing is bigger than
main unit base, please cut it out.
Construction process of anchor bolts.
1.Drill the anchor holes
of a specific diameter
and depth.
2.Clean each anchor hole
thoroughly using a
vacuum cleaner, with a
t
n
e
m
h
c
at
ta
e
lz
z
o
n
w
o
rr
a
n
to reach into the hole and
remove all debris.
3.Insert the anchor bolt, tapping
it lightly with a hammer to seat
it. Position the material, and
then drive the center pin into
the anchor unit it is snug.
4.Adjust the fastening strength
of the nut using a wrench etc.
Hold the Jig A and B to lift the unit by
2 workers to move it. Otherwise, breakage
may result in.
CAUTION
Carriage Jig A
Carriage Jig B
2. Hold the carriage jig and move the main unit to
marked position on the floo
r.
3. Decide the installation position and remove the
carriage jig A and B from main unit base.