■Neck cushion
Caution
At the end of work each day, wash the neck cushion with water, wipe them dry with a towel, and allow
them to dry in the shade.
If they are extremely dirty, wash with detergent diluted with water, and rinse carefully with
water.
The neck cushion is a consumable supply. Replace it if it is extremely dirty or the
surface has deteriorated.(available at additional cost)
● If solvents drip onto the neck cushion, rinse with water as soon as possible.
Failure to follow this instruction may cause deformation or discoloration.
● Clean the neck cushion every day. Leaving dirt uncleaned may cause them to get
moldy.
19
■Showerhead
1
Caution
Be careful not to pinch your hand or finger in
the wrench.
2
Rotate and loosen the air bubble fixture with the wrench.
3
Caution
The air bubble unit should be rinsed with running water
in the direction shown in the illustration below:
Running Water
Air Bubble Unit
4
After cleaning, set the three parts in the order shown in the
illustration.
5
Tighten the air bubble fixture with the wrench.
This completes the cleaning.
Wrench
Rubber Gasket
Air Bubble Fixture
Air Bubble Unit
Loosening
Tightening
The air bubble unit and the gasket can be reused after washing with water.
If replacements are required due to deterioration or breakage, however, contact your closest dealer.
The air bubble area of the showerhead should be cleaned
once a month (as a general guide). Apply the supplied
wrench to the chamfered portion of the air bubble fixture.
Remove the three parts (rubber gasket, air bubble unit, and
air bubble fixture) and wash with water using a nylon or
similar brush.
