Takara Belmont LUAR AB-MF, Руководство по эксплуатации

Страница: 22 / 32

20
Heat will escape and the
effective temperature reduced if
the customer's calves do not
contact the legrest. Use the
heater with the legrest raised.
The heater light is lit up in orange when the heater is operating. Always be sure to turn
off the heater switch when not necessary because using the heater for an extended period
causes the temperature to increase, possibly resulting in burns or fire. Turn off the power
if you feel abnormal heat when touching the legrest, and contact Takara Belmont or its
distributors.
Perform position setting of the preset function with a person sitting in the chair.
As this chair is equipped with a shockless device, setting the position without someone
sitting in the chair will result in slight variation of the final operating position.
(6) Heater
This chair is equipped with a legrest heater.
1 Operating the heater
Press the legrest heater switch
("HEATER") on the control panel (chair
left side) to operate the heater.
(Heater light turns on.)
2 Stopping the heater
Press the legrest heater switch again to stop heater operation.
(Heater light turns off.)
(7) Accumulator (OS Type)
This chair is equipped with an accumulator that reduces vibration when operating and stopping the
chair.
The accumulator absorbs loads applied to the chair to provide shock-free performance. Accordingly,
the following conditions might be observed.

The stopping position of the chair might vary due to slowly stopping the chair in order to absorb
shocks.

The chair might seem to slightly bounce due to load changes when getting in or out of the chair, or
during massage.

The chair might rise slightly when a customer gets out of the chair . (Due to the load applied to the
customer being absorbed when a customer sits, causing the chair to sink.)
Use Procedures
Left
Legrest
heater switch
CAUTION
CAUTION
NOTE