Takagi Flash Water Heater T-KD20, Инструкция по установке и руководство пользователя

Страница: 21 / 29

21
Optional Items
1. TKRE01emperature Remote Controller
The TKRE01
temperature Remote
Controller has two
functions, it allows the
output temperature
from the T-KD20 to be
adjusted within the
range of 95 °F to 167
°F, and it also works as a diagnostic tool that will
give a concise error code whenever there is a
problem with the unit. The temperature options
are 95°F, 100°F, 102°F, 104°F, 106°F, 108°F,
109°F, 111°F, 113°F, 115°F, 117°F, 122°F,
131°F, 140°F, 158°F, and 167°F. See the trouble
shooting section for information on possible error
codes.
3. TK-TV03 Vent Damper
The TK-TV03 Vent
Damper prevents the
backflow of air
through the exhaust
vent. This is CSA
approved part of the
unit. This helps prevent harmful exhaust gases
from entering the home, as well as helping to
prevent the units from freezing in areas where
cold air can be blown into the exhaust system.
Install vent damper according to manufacturer’s
installation instruction, and any applicable codes.
2. TK-TV01 Vent Terminator
This terminator can be
used where a T-KD20 is
going to be vented out
through a wall. This is a
CSA approved part of the
unit. Connect a Category
III Stainless vent pipe from
the top of the unit to the
backside of this terminator to exhaust flue gases
through the wall without a thimble. Install vent
terminator in accordance with manufacturer’s
installation instructions and any applicable local
codes.
5. TK-BK01 Wall Mounting Brackets
The TK-BK01
Wall Mounting
Brackets allow
the T-KD20 to be
installed hanging
from a wall. It is
not necessary to earthquake strap these heaters
if these brackets are used. If the unit is not going
to be mounted on a wall, the “L” brackets that are
included with every unit will be sufficient as
earthquake protection. Install unit and brackets
according to manufacturer’s installation
instructions and any applicable codes.