TAJIMA TFMX-IIC, Руководство пользователя

Страница: 45 / 268

Message display
31
Chapter 3
1
2
3
4
5
6
7
8
9
10
11
2.
Message display
2-1. Condition data
When registering the design (saving format is T3, or T2 design) saved in the USB memory into the machine
memory, the following message will appear.
There are following three items of condition data except the one described above. By setting them after data
set, each setting contents will be added in a design. Therefore, it is unnecessary to perform setting again
when you embroider this design next time.
(1) Scaling up/down/reversion of design
(2)
Design repetition
(3)
Automatic Offset
2-1-1.
When reading the design (Example: TAJIMA_W) saved in the USB memory by a personal computer
Indications in a personal computer are different as shown in the chart below depending on the saving format
(T3, T2, T) of the design.
[About T2]
One design consists of three types of file (TAJIMA_W.CT0, TAJIMA_W.DGF, TAJIMA_W.TBF).
Saving format
Indication in personal
computer
Use
T3 TAJIMA_W.TCF Data integrating CT0, DGF and TBF of T2
T2
TAJIMA_W.CT0 Color change sequence, design start point
TAJIMA_W.DGF Redeced-size design data (Thumbnail)
TAJIMA_W.TBF Stitch data of TAJIMA binary format
T TAJIMA_W.DST Stitch data of TAJIMA ternary format
Condition data means the following two items in this case.
(1)
Color change sequence
The whole color change sequence included in the design
can be registered into the machine memory. Therefore, it
is unnecessary to set it again.
(2)
Start point of design
The frame position where the machine started
embroidering last time can be registered in the machine
memory. Therefore, it is unnecessary to adjust the
position of the frame. "YES">>SET
"NO">>E
OK to read condition
data?