TAJIMA TFHX Series, Руководство пользователя

Страница: 78 / 140

CHAPTER 7 MANUAL OPERATION
71
6. POWER RESUME (TFHX-
II
, TFHX-
II
)
1. Machine stop code
Power resume function moves the frame to
the position where the power was shut off
during embroidery to prevent displacement
of design.
2. Selecting the thread trimming
Automatic thread trimming (ATH)
3. Search the origin
Move the frame by frame travel key to the
left of the front. When the frame comes not
to move, move the frame to the rear right
direction.
Set the frame travel keys to 8-direction
travel.
p.92
It is not possible to use jog remote-control-
ler.
4. Memorize the origin
When the position of the origin is searched,
[-] will switch to [o]. When the origins of
both axes are searched, make the machine
memorize the positions.
When the machine memorizes the origin, the
frame will return to the position where the
power was shut off.
WARNING
When performing this operation, do not put your hands under the
needle or on the machine table. If your hands are under the needle
or on the machine table, you may be injured by the needle or the
moving frame.
ATH - Not to perform thread trimming
ATH o To perform thread trimming
(GC07)
Turning on the power again
In case of power shut off by emergency stop,
turn “ON” the power to start operation.
In case of power shut off by power failure,
turn “OFF” the power and then turn it “ON”
to start operation.
!
Screen 1000
[2E3]
1
Screen 1000
ATH o
3
2
Screen 1000
X[-] Y[-]
Frame travel key
Screen 1000
X[o] Y[o] X[-] Y[-]
X[o] Y[-]
X[o] Y[o]
No detection
Detection of X-axis only
Detection of the origins of
4
both axes