TAJIMA TEJT II -C, Руководство пользователя

Страница: 40 / 45

3-8
Adjustment of each part
8.
Turn the tension nut (16) by hand to the direction where the tension block (17) moves outside, and apply further 4/6 turn from
the position where the tension nut stops by using the wrench.
To rotate the tension nut (16), take engraved numbers as rough standard.
9.
After tightening the screw (5) of the slide nut (18) on the right side, detach the wire tension gauge (13).
10.
Rotate the drive ring (20) by hand to align the center mark (3) with the needle hole (4).
11.
Move the frame to the crosswise direction by operation on the operation panel, and fix the wire stopper fitting (21) using the
nut (12).
Check if the groove position of the drive wire (6) is switched.
12.
Attach the base presser roller (11) using the nut (10).
This completes the working.
17
16
18
5
13
3
4
3
4
An example when the center of cap frame is misaligned
An example when the center of cap frame is aligned
20
11
10
21
12
21
6