IrDA (115.2Kbps, 2 meters) and ASK-IR (56Kbps). Install infrared module onto Infrared connector
and configure the setting through 'UART Mode Select' in Integrated Peripherals to select whether
UART is directed for use with COM2 or Infrared.
2.4.4 Wake-up on LAN Connector (3-pin JP1)
The JP1 connector powers up the system when a wakeup packet or signal is received from the
network . This feature requires the Wake up on LAN function in BIOS is set to Enabled and that your
system has an ATX power supply with at least 720mA +5V standby power.
2.4.5 Floppy Disk Drive Connector (34-pin JFLP1)
This connector supports the provided floppy disk drive ribbon cable. Orient the red stripe to pin 1
2.4.6 Primary/Secondary IDE Connector (Two 40-pin IDE)
These connectors support the provided IDE hard disk ribbon cable. Connect your first IDE hard disk
to master mode of the primary channel. If you have second IDE device to install in your system,
connect it as slave mode on the same channel, and the third and fourth device can be connected on
secondary channel as master and slave mode respectively.