17
1.
Connect antennas to RF ports of the ground unit.
2.
Adjust the remote controller to the training mode, if PPM mode is used, the remote
controller interface at the ground end is connected to the training port of the remote
control. If S.BUS mode is used, the cable connection between the S.BUS receiver
and the ground end need to be established, and the connection between the receiver
and the remote control need to be established.
3.
Connect the USB port of ground control station to the serial port of the ground unit
with TTL-USB cable if you want to use ViuLinx’s telemetry link.
4.
Connect cell phone or tablet to the USB port of the ground unit.
5.
If video view on a monitor is desired, connect a monitor to the HMDI port of the
ground unit.
6.
Turn on the ground unit.
7.
If latest firmware is desired, connect the ground unit to a PC or a Laptop using USB
cable and run ViULinx
TM
PC program to upgrade the firmware of the air unit to the
latest one.
8.
After downlink and uplink are connected, both LEDs will be on.
9.
Run ViuLinx
TM
APP on your phone or tablet. QGC is also supported. You can
watch the video on phone or tablet with ViuLinx
TM
or QGC APP.
