Taie FA Series, Руководство по эксплуатации

Страница: 35 / 66

34
9.5.2 Description of operation
1. There are 2 patterns can be used
，
each pattern contains 8 segments.
2. Terminologies
Pattern
：
A program consists of some steps.
Ramp status
：
The status with changing SV.
Soak status
：
The status with fixed SV.
3. Operating
I. "KEY" function (no changing parameter)
(RUN)
：
Start program procedure
，
PRO LED in panel start flicking.
(HOLD)
：
Suspend program procedure
，
PRO LED in panel will stop
flicker but still light on.
+ SET (JUMP)
：
Jump to previous segment.
+ SET (RESET)
：
Reset program procedure
，
PRO LED in panel will off.
II. Alarm Function
：
ALD1 = “07”(Segment end alarm)
，
AL1 =“2”(It means when segment 2 end,AL1 will act)
，
ALT1 =“00:10” (Relay on time is 10 seconds).
＊
In this case
，
when program proceeds to segment 2 end
，
the relay of AL1 will
be on 10 seconds.
III. END function
：
The Controller doesn’t have END order, so if program procedure is less than 8
segments, please set the last segments OUT to “0”. Program will end in this
segment. Otherwise
，
it will proceed 8 or 16 segments.
IV. Linking Function
：
PTN =1 proceed pattern 1
，
contains 8 segments.
PTN =2 proceed pattern 2
，
contains 8 segments.
PTN =0 linking proceed pattern 1 and 2 totally 16 segments.
(Please set PTN1 and PTN2 at first
，
and then set PTN to 0)
V. Other function(
＊
refer to LEVEL 4)
SET 8_1=1 Program repeats.
SET 8_2=0 No power failure function.
SET 8_2=1 Enable power failure function.
(When power shut down and on again
，
the controller will start from the
segment which is near PV)
SET 8_3=0 Program starts from 0.
SET 8_3=1 Program starts from PV.
SET 9_2=0 Timer Unit = “Hour: Minute”
SET 9_2=1 Timer Unit = “Minute: Second”
All manuals and user guides at all-guides.com