Taiden HCS-5100Plus, Инструкция по установке и эксплуатации, Страница: 58 / 99

2) Setting up “Subnet Mask” and “Gateway”:
Same chronological order as for the “IP address” set
up.
3.6.11 Use Testing Audio
The transmitter goes to testing mode and testing tone
will be distributed to all output channels.
Press the operation knob to stop the testing mode.
3.6.12 Backup/Restore
System parameters can be backed up or restored through
the panel USB port. Make sure that the USB disk is
properly connected; otherwise it will prompt “Please insert
the USB disk.”
a). Rotate the operation knob to select “Backup” or
“Restore”;

If “Backup” is selected, system parameters can
be backed up;

If “Restore” is selected, system parameters can
be restored;
b). Press the operation knob to confirm and to go to
selected menu item;
c). Return to upper level menu after backup and reboot
after recovery.
3.6.13 Machine Rename
Set alias for the HCS-5100M with a maximum length of
16 characters or less.
Rotate the operation knob to move the cursor, then
press the knob to modify the character; turn the knob to
left to clear all characters after cursor, and turn the
knob to right to select the new characters. Press the
knob to save at each character. Select “Return” to the
upper level menu after setting finished.
3.6.14 Screensaver
The main unit will enter screensaver status if no
operation in 3 minutes when enable.
a). Rotate the operation knob to select “Enable” or
“Disable”;
b). Press the operation knob to save and return to the
level menu.
3.6.15 About
Transmitter firmware information will be displayed,
including: version, main unit information and product
series number. Press the operation knob to return to
the upper level menu.
Note :

“IP address”, “Subnet Mask” and “Gateway” of
the system software should correspond with
the above transmitter settings, else connection
error will occur.
47