__________________________________________________________________________________________________________________
TAGLab
Battery Charger |
C4
Safety Functions
•
The charger features the following safety features to prevent damage to the charger and the battery or the
vehicle:
o
Short Circuit Protection (defective battery),
o
Reverse Charge Protection (connected with reversed polarity),
o
Sparking
o
Over Heat Protection
o
Over Current Protection
o
Over Charge Protection
Trouble shooting
•
Common problems and solutions:
•
No display: check the mains cable and the current connector.
•
For safety sake, a battery voltage of at least 2.5V is required to start a charge.
•
Separate the charger from the mains and check the connection
Error
Possible Cause
Solution
The “Error” LED
indicator lamp
(9) goes on
Battery defective.
The battery voltage is less than 1.5V and
greater than 0.5V
The battery voltage is less than 5V for a 6V battery
or less than 11V for a 12V battery after charging
the battery for 4 minutes
Battery voltage is under 6V or 12V after 2
minutes of fully charging
Unable to fully charge within 24 hrs.
Have the battery checked by a
specialised workshop
Change the battery.
Battery incorrectly connected / not connected.
Disconnect the charger and check
the connections.
Battery voltage selected not correct (6/12 V)
Disconnect the charger and wait for
the LED indicator lamps to go out.
Then reconnect the charger and
adjust to the correct battery
voltage.
