Taga Harmony TRS Series, Инструкция по эксплуатации

Страница: 4 / 16

4
Speaker Placement and Set-up
4. Connect the sound source
(for TRS L models check point 5)
Before connecting the speaker make sure that your
audio source (amplifier, receiver etc.) is switched off.
Connect the speaker cable to the speaker and
amplifier.
Pay attention to connecting the polarity of the speaker
correctly with the amplifier speaker output terminals.
Each channel of your amplifier has 2 speaker output
terminals: one is + (usually RED color) and one is -
(usually BLACK color). Please refer to your amplifier’s
instruction manual for more information.
Mono TRS Speaker
A pair of short speaker cables is located at the bottom of your TRS speaker (protected
by an external black sleeve): one cable is + (RED color) and one is - (BLACK color).
Use a speaker cable to connect TRS speaker cables with your amplifier.
Each channel of your amplifier should be connected to a single speaker. The amplifier
output speaker terminal marked with + should be connected with + (RED color)
speaker cable of your TRS speaker and the one marked with – should be connected
with – (BLACK color) speaker cable of your TRS speaker.
SM (stereo / mono) TRS Speaker
2 pairs of short speaker cables are located at the bottom of your TRS SM speaker
(each pair is protected by an external black sleeve). The pair for Left channel is marked
with L on the speaker’s cabinet, the pair for Right channel is marked with R on the
speaker’s cabinet. For each channel: one cable is + (RED color) and one is - (BLACK
color). Use a speaker cable to connect TRS speaker cables with your amplifier.
Both channels of your amplifier can be connected to a single SM speaker.
The amplifier Left output speaker terminal marked with + should be connected with Left