8
07/11/2016
A Ground Breaking Company Since 1923
Additional Tasks
“Menu”
takes you to screens that enable you to configure and diagnose the machine's
settings.
“Empty”
takes you to the “Run Hopper to Empty” screen in the off mode.
This screen allows the operator to nominate the “rpm” and “seconds” for the
"Run Hopper to
Empty"
for the selected hopper. The “Off/On” button allows overall control of this function.
The “<” and “>” buttons selects the hopper.
“Speed Diag”
enables the operator to verify or enter the “Relative/Distance” settings.
“Diagnostics”
allows the opera
tor to verify speed “RPM”, “Pwr” and “Cnt” for the hopper
selected. The operator can nominate the RPM using the “Set RPM" button. The <" and">"
buttons enable you to select another hopper. The controller will show the newly selected
hopper in the “Off” condition. When you have completed this task press the "Back" button.
“Settings”
shows the operator the actual settings for the machine. No changes can be made
on this screen. The left hand side of the screen shows the machine 'Configuration Settings"
and on
the right hand side the information about the selected hopper. Press the ">” or “<"
buttons to go to another hopper. When you have completed this task, press the "Back"
button.
"Area Reset"
when selected shows "No" which reverts to the "Menu" screen and "Yes"
which resets the area for the "ha" screen.
"Date/Time"
allows the controller to be adjusted for the current time in the time zone of your
country. The "Set" button sets the revised time and "Back" button goes back to the original
settings.
"Fan"
Controls and Settings
This screen is where you set the parameters for the "Warning" for the fan. (turbine)
Minimum RPM (0-5000)
Maximum RPM (0-5000)
When selected, the minimum rpm shows "red" on both the top indicator and the "Fan rpm" in
the "GO" mode, "green" when in the operating zone and "red" when over speed.
"Run Lockout" locks out the warnings.
When the "Fan" is configured, the machine will not perform the calibration task if the fan is
operating.