Tadiran Telecom SMVH09A-2A1B1NA, Руководство по обслуживанию

Страница: 23 / 68

20
Installation Manual
7.3 Installation Indoor Unit
Step 1: Choosing installation location
Recommend the installation location to the client and then confirm it with the client.
Step 2: Install wall-mounting frame
1. Hang the wall-mounting frame on the wall; adj ust it in horizontal position with the level meter and then point out the screw fixing
holes on the wall .
2. Drill the screw fixing holes on the wall with impact drill (the specification of drill head should be the same as the plastic expansion
particle) and then fill the plastic expansion particles in the holes.
3. Fix the wall-mounting frame on the wall with tapping screws (ST4.2X25TA) and then check if the frame is firmly inatalled by pulling
the frame.If the plastic expansion particle is loose, please drill another fixing hole nearby.
Step 3: Open piping hole
1. Choose the position of piping hole according to the direction of outlet pipe. The position of piping hole should be a little lower than
the wall-mounted frame, shown as below.
Left
Wall
Φ55mm
Right
Mark in the middle of it Level meter
Rear piping hole
Wall
Space
to the
wall
above
150mm
Space
to the
wall
above
150mm
Φ55mm
Rear piping hole
Left
Wall
Φ55mm
Right
Mark in the middle of it Level meter
Rear piping hole
Wall
Space
to the
wall
above
150mm
Space
to the
wall
above
150mm
Φ55mm
Rear piping hole
2. Open a piping hole with the diameter of Ф55/Ф70 on the selected outlet pipeposition.
In order to drain smoothly, slant the piping hole on the wall slightly downward to the
outdoor side with the gradient of 5-10°.
indoor outdoor
5
～
10
°
Ф55
Note:
● Pay attention to dust prevention and take relevant safety measures
when opening the hole.
● The plastic expansion particles are not provided and should be
bought locally.
09K 12K
Left
Wall
Φ55mm
Right
Mark in the middle of it Level meter
Rear piping hole
Wall
Space
to the
wall
above
150mm
Space
to the
wall
above
150mm
Rear piping hole
Φ55mm
18K