RX
Used only during Dealer programming.
TX
Appears when the radio is transmitting.
SCAN MODE
When the “SCAN” indicator is “on” the radio will scan all the channels that have been entered into the scan
sequence whenever the microphone is hung up. When the radio comes to a channel that is busy it will stop and
stay on that channel for the duration of the “scan resume time” that has been programmed in the “User
Programming” mode or until the channel becomes clear. If a tone is programmed into the RX, it must be valid as
well, unless the Monitor function is on.
PRIORITY MODE
When the “PRI” indicator is “on” the radio will continually sample the status of the priority channel. If the priority
channel becomes busy the radio will “beep” and stay on the priority channel until it becomes clear.
“Pr” plus the
priority channel number will be displayed on the display. If the mic is taken off hook, one of the following will
happen, depending on how your dealer has set the priority option.
1) The radio will always revert to the “PRI” channel.
2) The radio will revert to the priority channel only if the radio is not on a busy channel. If the radio
is on a busy channel, when the mic comes “off hook” the radio will stay on that busy channel until
the mic is placed back on hook.
USER PROGRAMMING MODE
The “User Programming” contains four separate modes.
i)
Bank number select.
(if available)
ii) Priority channel select.
iii) Monitor on/off select.
iv) Scan delay select.
Please Note:
a) To enter “User Programming” press the “PRG” button.
b) Once in the “User Programming” mode, use the “PRI” button to select the desired mode.
c) In the “Priority channel select” and the “Bank number select” mode, use the “Channel knob” to
select a channel or a bank number. In any of the other three modes use the “DISP” button to
select the proper function.
Bank: 1, 2, 3, or 4.
The “BANK” mode in “User Programming” lets the user select up to four different “BANKS”
of frequencies depending on how the dealer has set up the radio. This means that
there can be up to, 4 times 99, or 396 channels installed in the radio. If there are no
frequencies installed in a bank it will display “CH ALL CLR”.
