Priority Channel
May be any valid channel.
Monitor on/off
Monitor ON = defeats tone muting while on hook unless Busy Channel Lockout has
been enabled on the channel. “MON” indicator is visible on the display when the
function is active.
Scan Delay :0, 3, 6, or C.
0 =
No delay , the radio will resume scanning as soon as the channel clears.
3 =
3 seconds delay, the radio will resume scanning after 3 seconds.
6 =
6 seconds delay, the radio will resume scanning after 6 seconds.
C =
The radio will resume scanning 3 seconds after the channel has cleared.
NOTE:
Each “BANK” is separate from the others so you cannot scan channels that are in another
‘BANK”. However, you can have separate Scanned channels, Priority channel and Scan resume
times, etc. for each “BANK.”
Channel Revert
Active when the radio is in the scan mode (the radio is scanning)
If the radio is scanning and not on a busy channel, when the USER takes the microphone “Off Hook”, the radio
will “REVERT” to the channel that was selected when the scan key was pressed to enter the scan mode. (This
channel does not have to be one of the scanned channels.)
However, if the radio hears a signal and stops on a channel and the USER takes the microphone “Off Hook”
before the radio resumes scanning, the radio will stay on that channel.
M10 DISPLAY MESSAGES
Indicates there are no frequencies programmed into this Bank.
The radio’s PLL is “out of lock”, on the present channel. If RX is active, no TX is
permitted. If TX is active the radio will beep and return to RX when the PTT is
released. Radio requires service.
