The “PRG” button puts the radio into the“User Programming Mode. The “U PROG” indicator, on the
display, will be “on” when in the user programming mode.
2- When the panel button is pressed and held until the second “beep”:
The “SCAN” (A/D) button adds or deletes the present channel from the scan sequence.
The “D” indicator is turned on when the channel is deleted from the scan sequence.
(The channel will not be scanned if it is deleted from the scan sequence).
When adding or deleting channels, it is recommended that you be out of the SCAN Mode,
thus viewing all the channels in the Group.
The “DISP” (DIM) button toggles the display backlighting between dim and normal.
The “PRI” (L/N) button toggles the receiver between “normal” and “low”sensitivity. (The “LOW” indicator
is on when the receiver is least sensitive. This is useful in areas where very strong interfering signals
are present.The receiver is reset to the “Normal” condition everytime the radio is turned off.)
The “PRG” button provides access to further programming by an authorized person. (Dealer)
MIC connector
This is used to connect the microphone to the radio.
Cloning Plug
Used to connect to another M10 radio,or to a PC, to clone information.
or program the radio.
