3
3.
If the receiver’s LED fl ashes once and then stays on, the Rx is already
bound to the Tx and you can skip to the next section. Otherwise, push
and hold the receiver’s “BIND” button until its LED glows red and then
turns off after about one second.
4. Release the bind button.
5.
If the binding is successful, the LED will fl ash once and then remain ON.
6.
Test for proper Tx / Rx functionality by completing the next section. If it
doesn’t seem the radio has bound properly, repeat steps 1-6 above.
INSTALLATION
Receiver:
Mount the receiver as specifi ed in your model’s instructions. As a
guideline, mount in a secure location using double-sided tape. Route the servo
wires so they do not interfere with any moving parts. For boat applications,
it’s highly recommended to wrap the receiver in a balloon or enclose it in a
water-tight box.
Servos:
See the SERVOS AND ACCESSORIES section at the end of this
manual for a full list of optional servos. CENTER THE TRIM DIALS on the
Tx. Mount the servos inside the model and connect the linkages to the servo
using an appropriate length servo arm. Make sure all mechanical linkages are
free of obstructions and can move
smoothly. Connect the servos to the
receiver as shown in Figure 3. Turn
the transmitter’s trim dials to fi nely
adjust the servo’s center point as
needed to match the installation.
Electronic Speed Control (ESC):
If using an electronic speed
control, connect it to channel 2 of
the receiver (throttle). Center the
transmitter’s throttle trim and follow the ESC instructions for programming.
Switch / Battery:
It may not be necessary to use the included switch harness
and 4-cell battery holder if using an optional electronic speed control (ESC).
Check the instructions with your ESC for further information. Otherwise,
mount the included switch harness into the model as instructed in the model’s
manual and insert the switch harness’s proper mating plug into the receiver’s
“B” slot (top). For off-road environments, it’s a good idea to wrap or enclose
the switch harness to prevent dirt from entering the switch and causing poor
operation. Insert four “AA” alkaline, NiCd, or NiMH batteries in the included
4-cell battery holder (note proper polarity). Connect the battery holder to the
switch harness and the switch harness to the B slot.
Figure 3
(1) Steering
Servo
(B) Battery /
Switch
(2) Throttle
Servo
Link
Button
Link LED
Channel 3
