7
●
NEVER
allow the transmitter’s throttle trigger to accidentally be moved
away from the neutral position while the vehicle is powered up.
●
ALWAYS
range check the radio system before use.
●
ALWAYS
make sure that all transmitter movements operate all servos
properly in the model.
●
Do not store your radio equipment in extremely hot or cold locations, in
direct sunlight, or in locations with high humidity. Store R/C equipment in
a cool and dry location.
●
Do not allow chemicals to come in contact with any parts of the radio
system. Substances such as glow fuel, gasoline, CA glue, etc. could
permanently damage plastic parts of the radio system.
●
If rechargeable batteries were installed in the transmitter, remove the
batteries before placing the radio in long-term storage.
TROUBLESHOOTING
RANGE IS SHORT:
Interference –
check Rx installation and servo connections.
Low Tx or Rx battery –
replace the batteries or recharge if applicable.
Crash
damage –
send the radio to Hobby Services for repair
.
RUN TIME IS SHORT:
Low Tx or Rx batteries –
replace the batteries
. Obstructed
servo linkages causing excess battery drain –
free the linkages/pushrods.
Tx POWER SWITCH ON BUT SERVOS DO NOT FUNCTION:
Tx or Rx
batteries are low or –
replace the batteries or check Tx or Rx battery polarity
.
Switch harness or ESC is connected incorrectly –
check all connections and
the ESC instruction manual
. Rx is not binded to the Tx properly –
perform
binding process again
. Rx antenna located too closely to engine, motor,
servos or other moving mechanical parts which might be creating unwanted
electrical noise –
relocate the Rx inside the model or relocate the ESC
.
INTERFERENCE OR SERVOS GLITCHING:
Out of range –
operate the
model more closely to the transmitter
. Outside radio interference (pagers,
strong industrial or other commercial transmitters in the area) –
check your local
R/C club for confi rmation of dangerous/interfering frequencies in your area.
CONTROL SURFACE MOVES IN THE WRONG DIRECTION:
Change the
position of that channel’s reversing switch.
ONLY ONE SERVO GLITCHES:
Servo is bad –
replace the servo or send to
Hobby Services for repair.
Contact Hobby Services for other problems.
