Tack life PMS03, Руководство пользователя, Страница: 17 / 20

5. COMBINED MITRE CUTS
- EN -
The mitre angle and the vertical angle must both be set for combined mitre cuts.
This process is used, for example, to make picture frames, for cutting strips and for making
crates using angled side walls and also for roof trusses. Always test the cut first using a piece of
waste wood before you cut the actual material.
Use the drag function for sawing wide workpieces.
12. Maintenance and care
CAUTION.
- Never attempt to use a saw blade which exceeds the maximum specified size for the saw.
The saw blade could come into contact with the safety hood.
- Never use saw blades which are excessively thick which will prevent contact between the
external saw blade washer and the flattened parts of the spindle. This means that the saw
blade cannot be secured correctly to the spindle with the saw blade screw.
- Do not use the saw to cut metal or masonry.
- Please note that the spacers and spindle rings which may be required are suitable for the
spindle and the saw blade you wish to use.
- The mains cable must be disconnected from the mains supply.
1. CHANGE SAW BLADES
1) Press the control lever (7) downwards and pull the release knob (6) to release the sawing
arm (5). The release knob can be locked in the released position by turning it. Move the
sawing arm (5) into its highest position.
2) Remove the Philips screw which secures the saw blade screw cover (14). (B26)
3) Pull the moving safety hood (12) downwards and then swing it upwards together with the
saw blade screw cover (14).
4) If the moving safety hood (12) is above the top, fixed safety hood (9), the saw blade screw
is accessible.
5) Hold the moving safety hood (12) in its top position and press the spindle locking button
(25). Turn the saw blade until the spindle locks.
6) Remove the saw blade screw using the hexagonal wrench (19). (Turn the wrench clockwise
since the saw blade screw has a left- handed thread).(B27)
7) Remove the external washer and the saw blade.
Apply a drop of oil to the internal and external washers at the places in which it is in contact with
the saw blade.
Secure the new saw blade on the spindle. Ensure that the internal washer is located behind the
saw blade.
CAUTION. Always fit the saw blade so that the teeth and the arrows printed on the side of the
saw blade point downwards so that the saw blade will rotate in the correct direction. There is
also an arrow on the top safety hood to show the direction of rotation of the saw blade. (B28)
8) Fit the external saw blade washer again. Press the spindle locking button (25) and fit the
saw blade screw again.
- 15 -