Tack life PMS03, Руководство пользователя, Страница: 13 / 20

- EN -
● Protect the saw blade from impacts and shocks. Do not exert any lateral pressure onit.
● Caution. The saw blade will continue to turn after the machine has been switched off.
● The saw blade will become very hot during use. Do not touch it until it has cooleddown.
● Select the appropriate saw blade for the material that you wish to saw.
8. Before starting
● Assemble the machine in a stable position, in other works on a workbench, a sub-frame or
the like. Secure it if you wish to use the machine on a stationary basis.
● Before starting the machine, check that all covers and safety equipment are correctly fitted.
● The saw blade must be able to run freely.
● Check all the moving parts to ensure that they move easily.
● Before you connect the machine, check the information on the rating plate against the mains
data.
9. Transport
Only lift the mitre saw if the sawing arm is locked in its lowered position, the saw is switched off
and the mains plus has been pulled.
The saw may only be lifted using the carry handle
(8) or the external cast parts. Do not hold the saw by the safety hood or control lever (7) to lift it.
(B1)
10. Assembly
ASSEMBLY ON THE WORKBENCH
There are holes on the foot of the saw to make it easy to install it on a workbench.
Secure the saw on a straight, flat workbench. (B2) Insert suitable screws (not supplied) through
the installation holes in the foot of the saw for this purpose.
NOTE: If necessary you can also secure the saw to a piece of plywood with a minimum
thickness of 13 mm. The plywood may be secured on a working sarea using clamps or
transported to another workplace and secured there.
CAUTION. The fastening surface must be flat. An uneven surface may result in the saw blade
jamming or imprecise cutting.
FITTING THE SIDE SUPPORT (B3)
Place the two guide rods into the side supports and secure them.
The chip bag (15) will fit on the connect for the extractor (26). To ensure efficient operation, you
should empty the chip bag when it is half full. (B4)
ADJUST BENCH PERPENDICULAR TO THE SAW BLADE
Pull the mains cable out of the socket.
Press the sawing arm (5) into the lowered position and press the release knob (6) to lock the
sawing arm in its transport position. (B5)
Release the mitre angle lock (24).
Turn the mitre bench (20) until the pointer points to 0°. (B6)
Tighten the mitre angle lock (24).
- 11 -