Tack life PMS03, Руководство пользователя, Страница: 16 / 20

- EN -
curves inwards is placed against the guide rail, the board may snap and jam the saw blade.
3) When sawing long boards, support the end of the board level with the saw bench using the
side supports (35), a roller frame or a worktop.
4) If possible use the clamping device (10) to clamp the workpiece securely.
The clamping device (10) can be removed after the lock (11) has been undone and then
fitted on the other side of the bench. When using the clamping device ensure that its lock is
secure. Before you switch on the saw carry out a dry run of the sawing process to ensure
that no problems occur. (B23)
5) Hold the control lever (7) securely and press the release switch (23). Wait until the saw
blade has reached maximum speed.
Press the release switch (34) and slowly lower the saw blade into the workpiece and through the
workpiece.
Let go of the release switch (23), wait until the saw blade has reached a standstill and only raise
the saw blade again at this point. Do not remove the workpiece until the saw blade has reached
a standstill.
3. CROSS CUTS (WITH DRAG FUNCTION) (B24)
For sawing wide workpieces the drag lock (28) must first be released.
Pull out the locking knob (6), raise the sawing arm
(5) to its highest point and slide it towards you. Press the release switch (34) and slowly lower
the saw blade on to the workpiece. Move the sawing head away from you as far as possible as
you do so.
Press the release switch (34) and slowly lower the saw blade on to the workpiece.
Slide the saw away from you as you do so.
Let go of the release switch (23), wait until the saw blade has reached a standstill and only raise
the saw blade again at this point. Do not remove the workpiece until the saw has reached a
complete standstill.
4. VERTICAL ANGLE CUTS (B25)
A vertical angle cut is carried out across the grain of the workpiece with the saw blade at a
certain angle to the guide rail and the mitre bench. The mitre bench must be set to 0° and the
saw blade must be set to an angle between 0° and 45°.
Use the drag function for sawing wide workpieces.
Repeat steps 28 and 29 in point 3 Cross cuts (with drag function).
Release the vertical angle lock (16) and move the sawing arm (5) to the left to the required
vertical angle (between 0° and 45°). Tighten the vertical angle lock (16).
Repeat steps 30 and 31 from point 15 Adjusting the cutting depth.
- 14 -