Tabor Electronics 9100A, Руководство пользователя

Страница: 13 / 48

9100A/9200A/9400
Installation 1-5
Preparation for
Use
Preparation for use includes removing the instrument from the box,
the bag and installing the 9400 either on the bench or in a 19” rack.
Chapter 2 of the manual contains operating instructions. Make sure
you read and understand the instructions in Chapter 2 before
turning on the device.
Bench
Installation
The 9400 dissipates large amount of power. No special cooling is
required. However, the instrument should not be operated where
the ambient temperature exceeds 40
°
C, when the relative humidity
exceeds 80% or condensation appears anywhere on the
instrument. Avoid operating the instrument close to strong magnetic
fields, which may be found near high power equipment such as
motors, pumps, solenoids, or high power cables. Always leave 4 cm
(about 1.5 inches) of ventilation space on all sides of the
instrument.
Rack Mounting
The 9400 can be rack mounted inside a standard 19” rack. It can be
mounted using one of two configurations: 1) single, or 2) side-by-
side. Tabor offers rack-mounting ears for both options. Consult the
factory for the appropriate part number.
Using the single rack mounting option, the 9400 is supplied with a
blank panel that covers the empty side. The case can be mounted
either on the left or the right of the rack with the blank panel
covering the empty space.
Side-by-side option is available only with other Tabor products. In
this case, the two boxes are latched in the middle and side ears
connect the assembly to the rack. Figure 1-1 shows how the 9400
can be mounted next to a dual-channel arb – Model 2572.
Use care when rack mounting to locate the instrument away from
sources of excessive heat or magnetic fields. Always leave 4 cm
(1.5 inches) of ventilation space on top and bottom sides of the
power amplifier.