T-Storm TS 120CC Edge, Инструкция по эксплуатации

Страница: 8 / 40

Enlarge the slot in the covering to allow the horn assembly to be dry fitted.
Tip: - If the horn assembly is a tight fit, insert one horn into a slot and ‘work’ it back a forth, and in and
out to loosen the hole. If necessary, use a small needle file to remove any stubborn excess glue. Repeat
this process for the other slot.
Now draw around the horn back plate and remove the horn assembly.
Carefully cut inside the mark you have just drawn with your hobby knife. Take care not to press too
hard with the knife; you only want to cut through the covering, not into the wood. Clean off the ink
using alcohol.
6