T-Storm TS 120CC Edge, Инструкция по эксплуатации

Страница: 10 / 40

Make up the servo pushrods using the turnbuckles and ball links as shown. Use the spanner found in
the spares bag in the accessories box to help.
Note: - There are two types of ball links in the hardware bag, one with a base on the brass ball and one
without. Be sure to install one of each type onto the turnbuckle. The end with the base is for the servo
arm end, the other end goes between the horns.
Tip: - Apply a little oil to the ball link to ease the insertion of the thread of the turnbuckle.
SERVO
END
HORN
END
The stabiliser has the servo holes pre-drilled for you. Carefully drop some thin cyano into the holes
to harden the plywood. Install the servo, then a 1.75” servo arm using the hardware that came with
the servo.
Attach the pushrod to the horn and arm using the supplied bolts, washers and nuts.
Tip: - apply a drop of blue threadlok to the nut end of the bolt to add some added security against the
nut coming undone.
Repeat the above steps for the other elevator.
8