T.O.M TSR-210, Руководство по эксплуатации

Страница: 18 / 32

TECHNICAL DATA
Asynchronous motor 230V – 50 Hz
Output 1500 W S6 25%
Idle speed no 5000 min
Carbide-tipped saw blade o210xo30x2.8 mm
Number of teeth 24
Tilting range -45°/0°/+45°
Mitre cuts 0° to 45° to the left
Sawing width at 90° 65 x 305 mm
Sawing width at 45° 65 x 210 mm
(double mitre cuts) 35 x 210 mm
Weight 15 Kg
Laser class 2
Laser wave length 650 nm
Laser output << 1mW
Laser module power supply 2x1.5V Micro (AAA)
.
It must be possible for the saw blade to run freely.
When working with wood that has been processed before, watch out for foreign bodies such as nails or screws etc.
Before you connect the machine to the power supply, make sure the data on the rating plate is the same as that for your mains
7.1 Setting up the saw unit (Fig. 1/2)
• To adjust the turntable (8), loosen the locking handle (10) by approx. 2 turns, which frees the turntable (8).
• Turn the turntable (8) and scale pointer (11) to the desired angular setting on the dial (12) and lock into place with the loc-
king handle (10).
• Lightly press the machine head (4) down while at the same time pulling the retaining pin (16) out from the motor mounting;
this causes the saw to move down to the lower working position.
• Swing the machine head (4) up until the retaining hook latches into place.
• The clamping device (19) and the workpiece support (20) can be fastened on both the right and left sides of the base plate
(9).
• By loosening the tightening screw (13), the machine head (4) can be angled to the left up to 45°.
BEFORE PUTTING THE MACHINE INTO OPERATION
ASSEMBLY
18