1. Your new trigger is shipped with the sensitivity set to MOST SENSITIVE.
The sensitivity adjustment is on the back side of the trigger. Remove the
black plastic cap using a micro screwdriver. To adjust, insert a small micro
flat head screwdriver into the plastic screw head, then slowly and gently turn
CLOCKWISE.
2. The adjustment can only turn ONE COMPLETE TURN. Damage will occur
to the plastic potentiometer if you turn it too far. We recommend you turn
the adjustment a fraction at a time, check the sensitivity, then turn a fraction
more to the desired sensitivity. We also recommend leaving the sensitivity
where you set it for launches. There is no need to keep checking sensitivity
after it’s been set once.
OUTPUTS
Your trigger has two independent outputs, one 1.3mm barrel connector and one
3.5mm mono audio connector which is compatible with Pocket Wizard Cords.
There is a small opening for the LED on the faceplate beside the microphone which
will illuminate when sound is detected only.
