T-Drill T-60, Инструкция по эксплуатации и список запасных частей

Страница: 8 / 46

I N S T R U C T I O N M A N U A L
2.2 Safety instructions for tool
Store idle tools – when not in use, tools should be stored in dry, high, or
locked-up place, out of the reach of children.
Don’t force tool – It will do the job better and safer at the rate for which it
is intended.
Dress properly – Do not wear loose clothing or jewelry. They can be
caught in moving parts. Use appropriate gloves and footwear. Wear
protective hair covering to contain long hair.
Use safety glasses – Also use face or dust mask if cutting operation is
dusty.
Secure work – Use clamps or a vise to hold your work piece. It’s safer
than using your hand and it frees both hands to operate the tool.
Don’t overreach – Keep proper footing and balance at all times.
Maintain tools with care – Keep tools sharp and clean for better and
safer performance. Follow instructions for lubricating and changing
accessories. Inspect tool cords periodically and, if damaged, have them
repaired by authorised service workshop. Inspect extension cords
periodically and replace if damaged. Keep handles dry, clean and free
from oil and grease.
Don’t abuse cord – Never carry a tool by its cord or yank it to disconnect
it from receptacle. Keep cord from heat, oil and sharp edges.
Disconnect tools – When not in use, before servicing, and when
changing accessories such as blades, bits and cutters.
Remove adjusting keys and wrenches – Make it a rule to check that
keys and adjusting wrenches are removed from tool before turning it on.
Avoid accidental starting – Do not use a tool if the power switch does
not turn the tool on and off. Do not carry the tool with your finger on the
switch.
Outdoor use extension cords
– When tool is used outdoors, use only
extension cords intended for use outdoors and so marked.
Check damaged parts
– Before further use of tool, a guard or other part
that is damaged should be carefully checked to determinate that it will
operate properly and perform its intended function. Check for alignment of
8