SystemBase sWiFi/all, Руководство пользователя

Страница: 33 / 36

sWiFi/all
User Manual
32
It is recommended to use Static IP instead of DHCP in COM
Redirector, TCP Server and UDP mode.
Local Port 4001
Designate the number assigned to the port. This port is used to
wait for network connection in TCP Server and UDP mode.
Target IP Address 0.0.0.0
Designate the IP address of the target to connect to in TCP
Client mode.
Target Port 4001
Designate the port of the target to connect to in TCP Client
mode.
Latency
0
Set up if you want to send continuously-received data from the
serial port to the socket at once.
For example, if a serial device transmits 100 bytes of text from a
serial device to a socket on the server via CS sWiFi/all, if the value
is 0, the data entered in bytes at a time is immediately sent to
the server through the socket, ensuring real time, but causing a
lot of traffic to the network. This can lead to poor performance
of the product, leading to loss of serial port data.
If this value is not set to 0, it buffers the data received several
bytes at a time, waits for amount of time set, re-buffers the data
if it is read again, and if it is not, it sends all the data back to the
socket, regarding that it has been received, so there is no traffic
problem caused by many packets, but real time cannot be
ensured.
(Setting Range : 0 ~ 1,000)
KeepAlive 60
Check the network status every set number of seconds after
socket connection and terminate or reset the socket connection
if network failure is determined.
Deactivated when set to 0.