Model
Item no.
Mark IV Zone 1 Digidish
Version
03 - 2008
EN
triax.com
BSkyB
Assembly Instructions
Страница 1: ...Model Item no Mark IV Zone 1 Digidish Version 03 2008 EN triax com BSkyB Assembly Instructions ...
Страница 2: ...etermining the correct side appropriate for the installation rotate the swing arm through 90 Secure into position by passing a second M6 x 16mm carriage nut and bolt through the rotation bracket and swing arm from whichever side is most convenient These bolts must be only finger tight and will be fully secured during final alignment 3 Fit a M6 x 16mm nut and bolt through the elevation bracket on t...
Страница 3: ...ing a spirit level to ensure the bracket is perfectly level 2 Mark and drill holes in the prescribed way and fix the bracket to the wall using 4 x M8 coach screws and nylon plugs Attach the Swing Arm to the bracket and secure in place using 2 x M6 x 16mm bolts and 2 x M6 Serrated flange nuts 3 Using a current digital satellite meter align the antenna to the Sky satellites using the approved proced...
Страница 4: ...m the top of a wall or within 2 brick widths of an edge 3 The antenna system must be assembled at the point of installation do not transport pre assembled 4 Ensure the LNB is at the correct skew setting for the area and the dish face is level and secure Always loosen the LNB clamp screw before adjusting the skew 5 Do not over tighten the bolts Copyright 2016 TRIAX All rights reserved The TRIAX Log...