4 Mounting
4.1 General notes
Attention!
The following points must be complied with during the mechanical installation to avoid
causing a defect in the device due to assembly errors or environmental in
fl
uences:
•
Before installation remove the device from the packing and check for any possible
shipping damage!
•
Assemble the device on a clean and stable base. Do not distort during assembly!
Use the appropriate mounting devices for proper installation of the unit!
•
Do not mount equipment on vibrating base!
•
When mounted onto lightweight walls, there must be no impermissibly high
vibrations or shock loads. Any banging shut of doors that are integrated into these
lightweight walls, can result in extremely high shock loads. Therefore, we advise
you to decouple the devices from the wall.
•
Do not allow drilling chips, screws and other foreign bodies to reach the device
interior!
•
The device should be installed in a location where it will not be disturbed, but at
the same time can be easily accessed!
•
Any cable ducts openings not used must be sealed!
•
Care must be taken to avoid direct radiation from the sun!
•
The device is designed for vertical installation (cable inlet down). A horizontal or
reclined installation is only permissible after technical release of the manufacturer!
4.2 Installation location for agriculture
In order to avoid damage caused by ammoniac vapours, the controller shall not be
installed in the stable, but rather in an outhouse wherever possible.
4.3 Temperature in
fl
uences during commissioning
Avoid condensation in the controller and functional faults attributable to condensation by
storing the controller at room temperature!
Operating Instructions
TCA 150D
Mounting
L-BAL-E119-GB 1318 Index 002
Part.-No. 00163357-GB
6/17
