Synway SHT-16B-CT/cPCI 2.0, Руководство по оборудованию

Страница: 18 / 25

Synway Information Engineering Co., Ltd
Using IPC
mainboard for both
/cPCI
ringing current and
SHT-16B-B2
battery feed
Table 2-4 Source of Ringing Current & Battery Feed and Alternative Jumper Configuration
on
Ste
With the board completely inserted, push the upper and bottom handles inwards at the
now
out
rem
Notes:
①
② ard home
hile the board is inclined
is powered on. However, as strong static
electricity may lead to damages, the operator should touch a grounded conductor
tic electricity on him before inserting the bo
Step 4: Connect to analog phone lines or other input signals.
There are two types of interfaces-RJ11 and DB44 connectors-on the SHT-16B-B2/cPCI
or SH
I rea on p , which correspond to the 16 voice channels
on PCI 2.0, SHT-16B-CT/cPCI/F SH 3
2.0
Each rear connection p n RJ11 jacks. Each RJ11 jack can be
connected to a 4-l corresponds to two channels (See
middle two pins correspond to an odd-n ed channel (e.g.
chann uter two pins to an even-numbered channel (e.g. the 2
nd
, 4
th
, 6
th
,
8
th
… channel). Pins in DB44 connector are illustrated and described in Figure 2-18 and
Table 2-5 below, following which users can connect them with 16 voice channels via a
Note:
Users should confirm the jumper configuration or reset the jumpers depending
real situation before using these boards.
p 3: Fit the board and the rear connection panel into a pair of empty slots on
the CompactPCI chassis.
same time until a ‘click’ sound is heard and the red locks flip into position. The board is
properly fitted. The voice board can be further fastened with screws (on the
side of the upper and bottom handles) for extended use and prevention of accidental
oval.
The rear connection panel should be inserted into the slot which corresponds to that
of the voice board.
Due to the structural design of the cPCI IPC, it is necessary to push the bo
into the slot until it can go no further, and ensure that it is not inclined at an angle
before applying lever action on the handles to secure it. Connecting parts on the
mainboard of the IPC may be damaged if:
(I) Handles are used too early
(II) Handles are used w
(III) Force on handles is not applied evenly.
③ Board insertion is allowed when computer
to discharge the sta ard.
T-16B-B3/cPC
the SHT-16B-CT/c
board.
r c anel onnecti
AX 2.0 or T-16B-CT/cPCI/MP
anel has eight 4-pi
n ead li
el), and the o
Figure 2-5): The
the 1
e that
umber
st
, 3
rd
, 5
th
, 7
th
…
SHT-16B-CT/cPCI 2.0, SHT-16B-CT/cPCI/FAX (MP3) 2.0 Hardware Manual
(Version 2.2) Page 14