SYNTHR SYNTHR3, Руководство пользователя

Страница: 24 / 38

Page 24
SYNTHR3 Manuel V1.01 EN
SEQ_10_0 T+0 STOP
LFO PWM DIR
>x4 50% -->
next ↕/Ok Esc
==SEQUENCER select==
1 >RECORD_MONO
[ -- free -- ]
next ↕/Ok Edit
==SEQUENCER select==
10 >ERASE SEQ
[ CHORD 12 Steps ]
next ↕/Ok Edit
==SEQUENCER select==
10 >MODIFICATION
[ CHORD 12 Steps ]
next ↕/Ok Edit

2
nd
screen : record a MONO sequence
The MONO sequencer s based on the duophonic mode, see above.
Reminder: The VCO1 is sent to the VCF1 which is sent to the VCA1. Review the
role of envelopes
.
After moving the cursor with the Next key and rotating the encoder once, the next screen is displayed and
confirmed with OK. A new screen will be displayed waiting for recording.
The STEP parameter will increment with each note played AND released. The note will be displayed. The number of
steps (STEP) cannot exceed 128.

Record a blank
Instead of pressing a note, press "BLANK" (button A), the step will be empty.

Recording a sixteenth note (Ratchet /2) or a triplet eighth note (Ratchet /3) or (Ratchet /4).
Press a note without releasing the keyboard, press " Ratchet " (button A) successively to select the type of
Ratchet and finally release the key.

Modify one of the notes during the recording process.
If you want to modify notes before validating your sequence, turn the encoder until you hear the note you
want to modify, then press the new note again on the keyboard or modify the desired ratchet.

Validate the sequence
Press "RECORD" on the encoder OK. If you press " ESC " (button B) the sequence will not be recorded.

3
rd
screen : record a CHORD sequence
The CHORD sequencer is based on
PARAPHONIC mode 1 , see above.
Reminder: The modulation envelope controls VCF1 and VCA1, the filter envelope controls VCF2 and the VCA
envelope controls VCA2.
Turn the encoder to display the following screen and confirm with OK.
A new screen will be displayed waiting for recording.
This time we will record 1 or 2 or 3 notes at the same time.
Reminder: Tuning the 3 VCOs in unison and selecting the destination of each
VCO on the MIXER.
Then what applies for the MONO applies for the CHORD. The different notes pressed will be displayed.
There is no longer a VCO2 parameter.

4
th
screen : sequence modification
In this mode, in the same way as during a recording by moving with the
encoder, you can go to the note or chord to be modified by pressing a new
note or chord on the keyboard, then validate with OK and finally Record.

5
th
screen : erase a sequence
After selecting the sequence number, go to ERASE and press OK, the sequence
will become "-Free-".