Copyright 2020 by Synthetic Sound Labs LLC - 3650 Digital Sequencer
Page | 7
•
END OUT:
Sends a gate pulse when a running sequence drops off the end (goes past 16 or hits a
LOOP step).
Run two sequencers in series: To make a 32-step sequence, connect END OUT of Sequencer 1 to START IN of
Sequencer 2, and END OUT of Sequencer 2 to START IN of Sequencer 1. Of course, if you have more sequencers
(or even other devices), you can daisy-chain as many as you want. You will also need to provide a common clock
pulse to the CLOCK IN of all sequencers in the chain.
AUTO ADVANCE
Purpose
Allows you to just play your sequence into the sequencer without having to press STEP UP in between each step,
making initial programming of a sequence easier.
Default
Disabled / Off
Operation
When enabled and you are programming a sequence, entering a NOTE or REST or LOOP into a step will
automatically advance to the next step.
To toggle AUTO ADVANCE mode, press and release both yellow STEP / TEMPO [AUTO ADV] buttons. The STEP
#16 LED will blink twice when enabled and flicker when disabled.
Important Notes:
Gate timing selection, SLURs, and ACC mode selection are not available in AUTO ADVANCE mode. You can enter
in the basic structure / notes of your sequence, then go back in normal PROGRAM mode and tweak the timings,
etc.
AUTO ADVANCE mode will stay enabled until the next time you put the sequencer in RUN mode, at which time it
will disable itself.
That is unless you enable…
