Syntec 60W-E Wood, Руководство по эксплуатации

Страница: 102 / 135

机床产品
/Machine Tool Products
–
60W-E Wood Operation Manual
How to Operate 60 Series Controller
–
•
•
•
•
•
•
•
•
•
•
•
•
•
System will excute process the current single block in program
System status will be switched from "Ready" to "busy" and backs to "Ready" when machining is
finished
Home
Because tool and workpiece coordinate setting is based on Machine zero point, it is necessary to make sure
where is machine zero (HOME). Therefore, when CNC restarts, return to reference point (search HOME) is very
important. Otherwise, SYNTEC CNC controller will not be allowed to execute AUTO NC files.
Operation:
Release emergency stop button, CNC status will change "NOT READY" to " READY "
Select HOME mode
Press axis direction key(X+,X-,Y+,Y-,Z+…) ,each axis would start HOMING
Home direction is defaulted in the CNC parameter
Home function can run 3 axes at the same time
After HOMING, all machine coordinates will be zero.
After HOMING, software stroke limit of each axis just is enable, so before HOMING, please do not
run machine too fast
4.3 Workpiece Preparation
4.3.1 Workpiece Coord set
The setting of Workpiece Coordinate will be introduced on this section.
Conditions
N/A
Operation Procedure