Syntec 60W-E Wood, Руководство по эксплуатации

Страница: 48 / 135

机床产品
/Machine Tool Products
–
60W-E Wood Operation Manual
Fenu and System Introduction
–
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Set the upper limit of part count number.
Once part count number is reached, an alarm will be pop up and system will change to halt
status.
Simulation Area
Description
Display the tool trajectory of current program.
Related setting, please see F2-program-> F5-simulaiton-> F5- Simu. Setting.
Use F2
「
Simulation Switch
」
to change the display content
3.7.2 Open File to Edit
Path
5 key, 8 key: F4 Monitor → F1 Edit
10+8 key: G4 Monitor → F1 Edit
Explanation
Load current machining file into the program editor and switch the screen to "Program".
Note
The screen will be switched to "Program" if this button is pressed during machining, but it's
unable to edit the current executing file.
3.7.3 Simulation Switch
Path
5 key, 8 key: F4 Monitor → F2 Simulation Switch
10+8 key: G4 Monitor → F2 Simulation Switch
Explanation
Show/Hide the simulation area.
The button "Graph Adjust" will only be enabled when simulation area is displayed on the screen.
3.7.4 MDI Input
Path
5 key, 8 key: F4 Monitor → F3 MDI Input
10+8 key: G4 Monitor → F3 MDI Input
Explanation
Edit the MDI executing program
Operation Method
Switch to MDI mode.
An editing block will appear after selected "MDI Input"
Edit the program and press OK to save the content in MDIBLOCK.
Press Cycle Start to execute the MDI program.
Note
This function is only enabled in MDI mode.
3.7.5 Parameter Set
Path
5 key, 8 key: F4 Monitor
→
F4 Param. Set
10+8 key: G4 Monitor
→
F4 Param. Set