8
low or the fluid in the USED tank is high, take the appropriate steps at this time to add NEW,
or empty USED fluid(s). See page 14 for instructions.
5)
Select EXCHANGE AMOUNT. LED light will remain on during the entire process until
complete. NEW fluid displays default to 12 and USED fluid display defaults to 0.
SEMI-AUTOMATIC EXCHANGE MODE (Continued)
6)
Enter the total amount of fluid to be exchanged using the increase (+), or decrease (-) buttons
until desired amount of fluid to be exchanged is displayed in NEW fluid display.
7)
Select SEMI-AUTOMATIC EXCHANGE mode. LED light will remain on until process is
completed. DRAIN PAN LED will begin to flash.
8)
Select DRAIN PAN function. LED light will remain on until process is complete and USED
fluid will now begin to be removed from vehicle. NEW fluid display will indicate the
remaining amount to be exchanged or NEW fluid to be added, and USED fluid display will
increase as USED fluid is removed from vehicle.
Unit will sense that all of USED fluid has been removed from vehicle transmission pan when
USED fluid level ceases to change for a period of twenty seconds. This step is complete when
DRAIN PAN LED turns off, READY light turns on, and alert sounds.
NOTE:
If NEW fluid tank does not have enough fluid to perform function or USED fluid tank does
not have enough capacity to perform function, the appropriate LED will light and alert will
sound. The exchange process will not occur until adequate tank capacities are obtained.
Reset unit, take the appropriate action to correct then repeat Step #5.
9)
The RESUME REFILL LED will begin to flash. Exchange can continue by depressing
RESUME REFILL button and NEW fluid, equal to the amount extracted, is pumped into
vehicle. NEW fluid display will decrease from the amount extracted down to 0 and the USED
fluid display is blanked. This step is complete when RESUME REFILL LED turns off,
READY light turns on, and alert sounds.
10)
Start and Run vehicle at idle for one minute, shifting through gears at least ten seconds of this
minute. SHUT-OFF ENGINE.
FOR A BETTER EXCHANGE RATIO:
Data accumulated has indicated
that using the following formula results in the highest
percentage of NEW fluid compared to USED fluid using this exchange method based on
average flow rates of vehicles tested.
AMOUNT EXTRACTED FROM VEHICLE / 3.25 = VEHICLE RUN TIME
Example: If the amount of USED fluid removed from the drain pan function is 5 quarts, divide
the 5 quarts by 3.25 which results in running the vehicle 1.5 minutes at idle and
shifting through the gears at least ten seconds.
Formula will provide the best ratio of new versus used fluid using this exchange
method based on data gathered to date.
