9
11)
Should the amount of USED fluid drained and NEW fluid refilled be less than the total amount
to be exchanged entered in Step 6, the DRAIN PAN LED will flash and NEW fluid display will
indicate the remaining amount of total fluid yet to be exchanged.
SEMI-AUTOMATIC EXCHANGE MODE (Continued)
Select DRAIN PAN function and USED fluid will now be removed from vehicle for a second
cycle. NEW fluid display will indicate the remaining amount of fluid remaining to be
exchanged and USED fluid display will increase as USED fluid is removed from the vehicle.
The
ATF
2
D
will sense that all of the USED fluid has been removed from the vehicle
transmission pan when the fluid level ceases to change for a period of twenty seconds, or if the
remaining amount to be exchanged is obtained, whichever occurs first. This step is complete
when the DRAIN PAN LED turns off, READY light turns on, and alert sounds.
12)
RESUME REFILL LED will begin to flash and the exchange continues by depressing the
RESUME REFILL button. NEW fluid, equal to the amount extracted in step #11, is pumped
into the vehicle. NEW fluid display will decrease from the amount extracted down to 0 and
USED fluid display is blanked. This step is complete when RESUME REFILL LED turns off,
READY light turns on, and alert sounds.
13)
Start and run vehicle at idle for one minute Shifting through the gears at least ten seconds of
this minute. SHUT-OFF ENGINE.
Refer to Better Exchange Ration notes in Step #10
14)
Steps 11 and 12 will keep repeating and need to be performed until the total amount to be
exchanged, entered in step 6, is obtained. Once the total amount to be exchanged is completed
from the last REFILL RESUME sequence, the unit will reset to the original power up mode.
15)
Upon completion of fluid exchange, remove dipstick extraction wand and check vehicle’s
transmission fluid level as specified. Add or extract fluid to achieve proper
fluid level by
re-inserting dipstick wand and selecting the appropriate ADD FLUID or REMOVE FLUID
buttons on the control panel. Additions are displayed in NEW fluid display while removals are
displayed in USED fluid display.
Addition and removal amount defaults to .5 quart. This amount can be increased or decreased
using the “ + ” or “ - “ buttons on the control panel. The desired amount will be extracted or
added upon depressing ADD FLUID or REMOVE FLUID button the second time. Repeat this
procedure until the proper transmission fluid level is maintained.
NOTE:
If NEW fluid tank does not have enough fluid to perform the ADD FLUID function or
USED fluid tank does not have enough capacity to perform the REMOVE FLUID
function, the appropriate LED will light and alert will sound indicating LOW TANK
LEVEL in NEW tank and/or HIGH TANK LEVEL in USED tank. Take the
appropriate action to correct and then repeat Step 15. See page 14 for instructions.
