5
The following information is intended to familiarize the
ATF
2
D
operator with the control panel and its
functions. It is
Control Panel Descriptions and Functions
not
The control panel is arranged in a very logical and intuitive manner that provides the required modes
and functions needed to perform successful preventative maintenance on automatic transmissions.
The operator starts at the top and works down the control panel. Look at the display upon power up to
view tank levels, to select mode of operation, to adjust Quart/Liter amounts of fluid as required, to start
functions to be performed, to verify function completed, and to continue to the next function if needed.
designed to replace the guidelines and safety warnings found in the remainder of
this document. The complete Operations Manual must be read and understood and the warnings must
be taken note of before operating the machine.
1)
NEW Fluid digital display
– Displays the amount of NEW transmission fluid in the NEW
tank when no modes are selected. It also displays the amount of fluid to be exchanged,
added, or the decreasing amount of NEW fluid being pumped from the unit. Amounts are
displayed to the nearest tenth in quarts or liters dependent upon unit of measure selected.
The display decreases in value for the NEW fluid being pumped out of the unit and increases in
value as the desired fluid amounts are keyed in or set for the various functions.
2)
USED Fluid digital display
– Displays the amount of USED transmission fluid in the
USED tank when no modes are selected. In all modes and functions, the USED fluid
display indicates increasing amounts of fluid being extracted from the vehicle during the
process selected. Amounts are displayed to the nearest tenth in quarts or liters dependent
upon unit of measure selected.
The display decreases in value for the USED fluid being pumped out of the unit and increases
in value as the desired fluid amounts are keyed in or set for the various functions.
3)
“ + “ Increase Button
– Adjustment button used to increase the amount of fluid, in tenths,
of a quart/liter to be transferred in each applicable mode and function.
4)
“ – “ Decrease Button
– Adjustment button used to decrease the amount of fluid, in tenths,
of a quart/liter to be transferred in each applicable mode and function.
5)
POWER
– Indicates that 12V DC power with a negative ground, either internally via
onboard battery, or externally via power cables, has been supplied to the unit through the
Main Power switch.
6)
STOP
– Button used to stop all modes and functions at any time. NOTE: If unit is stopped
during an exchange, all exchange amounts will be lost.
7)
“ Q/L ” QUARTS / LITERS
– Selection button and indication LED’s used to select and
depict the required unit of measure for volume measurements. Can only be utilized before
mode selection.
Failure to follow these instructions could endanger the operator and risk damage
to the vehicle.
