Symmetricom GoWide 9.2, Руководство пользователя

Страница: 20 / 134

20
GoWide 2.3 G.shdsl Bridge/Router – User Manual
Installation
097-91021-01 Issue 1: February 2002
S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S
2
Hardware Installation
)LJXUHVKRZVWKHFDEOHFRQQHFWLRQVWRWKH*R:LGHUHDUSDQHO&RQQHFWLQJWKH
3&WRWKH(WKHUQHWSRUWLVGHVFULEHGLQ3URFHGXUH$
Figure 3. GoWide 9.2 Rear Panel Cable Connections
Procedure A. PC Connection to the Ethernet Port
Step Procedure
1 Check that the Ethernet card and the TCP/IP protocol are installed on the PC before beginning installation. (If
the TCP/IP protocol is not installed, go to Appendix A for the installation procedures.)
2 Connect the Ethernet cable from any of the four GoWide 9.2 Ethernet ports to the PC NIC card or the server
NIC card.
3 Connect one end of the DSL cable to the DSL wall jack and the other end to the “DSL RJ-11” receptacle on the
back of the GoWide 9.2.
4 Connect one end of the power cord to the wall jack and the other end to the “AC POWER” receptacle on the
GoWide 9.2.
5 Turn on the GoWide 9.2 by placing the ON/OFF switch in the back of the device to the ON position. The
Power LED must be a steady green. The Sync LED will initially be a blinking green and will become a steady
green once the connection is established.
End of Procedure
$&32:(5 '6/ (7+(51(7 5(6(7
6:,7&+