www.symc-tec.com
The Chapter Two Software Operation Instruction
7
The Chapter Two Software Operation Instruction
2.1 Software start-up interface
This section will describe the capabilities of the controller program and give you a brief
understanding of how to use it
，
the star-up interface of controller is shown in Fig 2.1.The bottom
area of interface is used to connect controller.The center of interface is used for status
displaying.The top of interface is used for parameters setting and moving curve.
Fig 2. 1 Software start-up interface
2.2 Connect Controller
You need to connect the controller through a serial port before doing anything. The device
manager detects the new hardware but cannot assign the serial number to the controller if the
driver is not installed, so you need install the USB driver firstly and set the serial port parameters
as follows:
