fig. 14
fig. 15
4. Use the SCREW FOR WALL to attach the other end of SAFETY CABLE to the wall.
5. Make sure all screws are tight.
OPERATION
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach,
you may use an extension cord rated for a minimum of 1875 WATTS. Once the
fireplace insert has been properly connected to a grounded electrical outlet, it is ready
to operate.
OPERATION BY THE CONTROL PANEL
The controls are located behind the grill below the front glass and can be accessed by
pulling the grill from the top, forward and down.
ON/OFF: Press this button for main power and flame effect. The indicator light will
turn on. See below for other control switches.
750W: For low heat function - Press this switch while the ON/OFF switch is in the on
position for low heat. The indicator light will turn on.
1500W: For high heat function - Press this switch while the ON/OFF switch and the
750W switch are in the on position for high heat. The indicator light will turn on.
Temperature Control: To adjust the temperature to your individual requirements, turn
the temperature control dial to the right (clockwise) to increase the desired tempera-
ture and to the left for lower temperature. This temperature control dial can only be
used while the ON/OFF switch and 750W & 1500W switches are in the ON position.
When the heater reaches to the desired temperature, the heater and 750W/1500W
indicator light will off but the fan still keeps working with air flow. Adjust this knob to
restart the heater.
Dimmer Control Knob: Turn the dimmer dial clockwise or counter clockwise to get
the desired flame intensity. The dimmer switch can only be used when the ON/OFF
switch is in the on position.
Note: When the ON/OFF switch is turned off, all other heater functions will stop
even though the switches may be in the on position.
MAINTENANCE
NOTE: IN ORDER TO SHUT DOWN THE HEATER SAFELY, IT IS
RECOmmENDED TO TURN THE TEmPERATURE CONTROL KNOB TO
LOWEST SETTING AND ALLOW THE HEATER TO COOL DOWN BEFORE
PRESS THE ON/OFF SWITCH TO OFF POSITION.
MAINTENANCE WARNING:
Disconnect power and unplug the power cord before attempting any maintenance or
cleaning to reduce the risk of fire, electric shock or damage to persons. The bulbs in
your unit can become extremely hot. Allow at least 10 minutes between turning off
the unit and removing the light bulbs to avoid the accidental burning of the skin.
RISK OF FIRE: DO NOT ExCEED THE RECOmmENDED BULB WATTAGE.
REPLACING THE LIGHT BULBS
Step 1: Remove 4 screws on the back of fireplace and remove the rear cover
of the unit.
Step 2: You will find 1 X 40W Type B-10 bulbs under log-set bed.
Step 3: Loosen and remove burnt out bulb and replace with new bulb.
Step 4: Close the rear cover and secure with the 4 screws.
Step 5: Plug in the unit.
Содержание SQCM480AT-38CACO
Страница 8: ......