Logging on to SwyxServer
A-3
A.4
Logging on to SwyxServer
When you connect SwyxPhone L400 to the power supply, a restart will automatically be
initiated. The IP network configuration and the address of the PhoneManager are identified
during the start. This process may take several seconds in some cases.
Normally, for example after a power failure the SwyxPhone L400 will be logged on to
SwyxServer automatically. If you logged on for the first time or if your administratior has
deactivated the automatic logon, enter yout PIN and a '#' when all LEDs are blinking.
Always use the configuration via DHCP. The network settings cannot be displayed because
SwyxPhone L400 does not have a display. So you cannot change these settings. Therefore the
use of static IP addresses makes no sense.
In the SwyxWare-Administration please configure the 'Automatic Log on' for the SwyxPhone
L400. The user logged on cannot be displayed and it is not possible to log off the user. So the
sharing of the SwyxPhone L400 for several users makes no sense.
This is how you install SwyxPhone L400
Please note that for a successful assignment the automatic log on for the SwyxPhone must be
enabled and the field for the MAC address must be empty. Both are fullfilled creating a new
user using the configuration wizard.
1.
Start the SwyxWare-Administration and open the tab "PhoneController" under the
properties of the server.
2.
Configure the IP address range the IP address will be selected from (via DHCP) (e.g.
192.168.0.10-192.168.0.254 with PhoneManager address 192.168.0.2).
3.
Start the automatic configuration of SwyxPhone (Scan).
4.
Connect the Phones to the network and the power supply.
5.
All LEDs of the SwyxPhone L400 light short and remain dark for zwei minutes. There are
two options for this:
• Alle LEDs turn on
This status should take 30 seconds. Otherwise check the settings of the
PhoneController and verify, if he is active.
• All LEDs are blinking.
You can now enter the PIN. Enter the PIN of the user account you will this phone assign
to. End your input with '#'.
SwyxPhone L400 is ready for operation. If the user has already installed a SwyxIt! on his PC, he
can now use the SwyxPhone L400 with CTI.
Connect SwyxPhone
L400
Содержание SwyxPhone L400
Страница 10: ...Illustration of SwyxPhone L400 with a Description of the Buttons 1 4 ...
Страница 18: ...Telephoning with SwyxPhone 2 8 ...
Страница 30: ...Set It Up Log On A 4 ...
Страница 34: ...Index 1 2 ...